Commodore Amiga 4000 (A4000) — Commodore Amiga 4000 (A4000) User's Guide — Free Manual PDF Download

3-8 When Installing Internal Options 2. Disconnect any wires, ribbon cables, etc., that may be connected to the expansion board. A jumper consists of a row oftwo or more closely spaced metal pins projecting from the circuit board and a metal-lined plastic cap that can fit over two adjacent pins. The cap connects (shorts) the two pins. When two ofthe pins are connected by the cap, they are "closed;" pins not connected by the cap are "open." The combination of open and closed pins is the jumper's setting, which determines a specific hardware function. Note If all pins on a jumper must be left open, save the cap by covering only one pin of the jumper.

This keeps the cap handy if you need to change the jumper's setting in the future. 3. Remove the screw securing the expansion board's rear bracket to the Amiga's chassis. 4. Grasp the expansion board firmly near either end, and pull forward. You may have to rock the board slightly from side to side--not up and down-to loosen it in the slot. 5. If not installing another expansion board in the vacant slot, replace the slot's cover plate and secure it with the screw. Jumpers are small components on a circuit board that control a computer's or expansion unit's hardware configuration.

It is sometimes necessary to set one or more jumpers to change the default configuration of the computer, or to add an internal expansion device. 1. Once you have opened the Amiga, turn it so that the daughterboard faces you. Removing Expansion Boards To remove an installed expansion board: Setting Jumpers