Commodore Amiga 4000 (A4000) — Commodore Amiga 4000 (A4000) User's Guide — Free Manual PDF Download

3-9 To properly set a jumper you usually need to determine which pin is pin 1. The pin 1 end of the jumper may be indicated on the circuit board by either: A numeral 1 printed near one end ofthe jumper. A box with one pointed end printed around the jumper, with the pointed end being pin 1 (see Figure 3-3, top view). 3. Look up that jumper in the jumper table, noting its location on the circuit board and the required jumper cap position. Figure 3-3 shows the side and top views of a three-pin jumper in which pins two and three are closed. Sometimes the meanings of the jumper positions are explicitly labeled on the circuit board.

For example, the two positions of a three-pin jumper might be labeled "ENABLE" and "DISABLE". 5. Lift the cap off the pin(s) it currently occupies, and press it down in the new position. 1. Disconnect the Amiga and remove the system cover, as described earlier in this chapter. 2. Determine the name or number of the jumper to change. Top View 1 Pin 1 Figure 3·3. Typical jumper Side View H---- Jumper Cap 4. Locate the jumper on the circuit board. When Installing Internal Options ~--- Jumper To change a jumper setting: I Pin 1