6-2 Front Bay Installation In the rear of the main unit to the left of the power supply is the hard drive storage area, which can accept only 3.5-inch devices that do not require external access. This area can take one half-height drive or two low profile drives. If your Amiga came with a hard disk, a low profile drive is already there. Two standard full-size 4-pin power connectors are provided for rear- mounted devices. 3. Disconnect the keylock and the LED assembly wiring from the motherboard. 4. Remove the front faceplate. The faceplate has several plastic tabs that hold it to the metal chassis. Squeezing the tabs and pushing them through the chassis holes will release the faceplate.
You may need a small pair of pliers to do this. 5. Disconnect the power and ribbon cables from the existing drive(s) in the front area (see Figure 6-1). Note the orientation of the connectors before you remove them so that you can replace them properly when you are done. 2. Remove the Amiga's cover as described in Chapter 3. Front Bay Installation To install a drive in one of the front bays: 1. Turn off and disconnect the Amiga. Rear Bays