7-4 Identifying and Solving Problems If the Amiga comes on, but does not boot, check the following before suspecting a hardware problem: Notes on Hard Disk Systems If the Amiga comes on, but does not boot, check the following before suspecting a hardware problem: Did you insert a copy of your Workbench disk when prompted by the initial animated sequence? Did you insert the floppy properly into the drive? Is the Workbench disk you inserted an exact copy of your original Workbench disk, or a disk you know to be bootable? If the Amiga will not boot from a given disk, try others that you know to be bootable.
You should always keep your original, unmodified Workbench disk available in case of such a problem. If the Amiga will not boot from any floppy, even those you know to be good, then it is probable that the floppy drive or the computer itself has some hardware problem. Do you have a bootable hard drive partition in the system? Is the partition you want to boot from enabled, and does it have a boot priority above other bootable devices or partitions? Does your bootable partition have all the required directories and files available on it? If you have trouble booting from your hard disk, try booting from floppy.
If you can boot from floppy, then your hard disk setup, or something on your hard disk, probably is the source of the trouble. After booting from floppy you may still be able to access your hard disk to try to determine the source of the trouble. Typical disk drive hardware problems include: Notes on Floppy-Based Systems Disk Problems