Commodore Amiga 4000 (A4000) — Commodore Amiga 4000 (A4000) User's Guide — Free Manual PDF Download

Identifying and Solving Problems 7-5 A drive ribbon cable connector is inserted in its drive or motherboard connector(s) improperly (see Chapter 6, "Installing Optional Storage Devices "). A drive is not connected to power, or the power supply is overloaded (see Chapter 6). A drive ID or unit number jumper is set incorrectly (see Chapter 6). A drive controller board is not fully seated in its slot (see Chapter 5, "Installing Expansion Boards"). The device chain is not terminated correctly (SCSI drive systems). A hard drive takes too long to spin up to working speed. A drive or controller board has the wrong ROM version. A drive ribbon cable is faulty. A drive is faulty.

Installation problems are most likely to appear after you have added a new drive or other hardware item to the system. If you have a problem after installing additional hardware, remove the new item and see if the problem disappears. If it does, you know the problem is in that item or its installation. Repeat the installation, following the hardware manufacturer's installation instructions carefully. If you have several expansion devices, the problem may be an interaction between two or more items that by themselves work properly. Try running your system with different combinations of expansion devices to isolate the offending items.

If the item requires its own software, consider different settings the software may offer. Sections on disk use in Using the Amiga Workbench The Amiga Hard Drive User's Guide The drive's user manual Installation and Maintenance Problems For solutions to these problems, also check: