7-6 Non User-Serviceable Problems All SIMMs are fully seated in the proper sockets. All the SIMMs in the Fast RAM banks are the same size, either 1 MBor 4MB. The Fast RAM SIMM SIZE jumper setting matches the type of SIMM in the Fast RAM banks. No other jumpers have been moved from their factory-set positions. The processor module and the expansion slot daughterboard are fully seated in their slots. All expansion boards are fully seated in their slots and connected according to their instructions. All peripherals were properly reconnected to the Amiga after installation. A floppy, removable media, or CD-ROM drive is dirty or out of alignment.
Use a commercial drive alignment and/or cleaning product according to the drive manufacturer's directions, or have your dealer/service center look at the drive. The mouse ball or mouse ball rollers are dirty. Open the mouse ball cavity, remove the ball, and clean the ball and interior with a cotton swab. Connector pins are bent or dirty. Carefully clean and straighten the pins. If you still have a problem after trying the remedies suggested here, you may have a hardware problem that requires professional attention. Have your Amiga examined by your Amiga dealer/service If the fault is not in the new hardware itself, there may be a problem with its installation. Check to be sure that:
Non User-Serviceable Problems Refer to the installation sections of Chapters 1, 4, and 5. Installation Problems Maintenance Problems