Enabling Multicast Routing on the AppGigabitEthernet Interface SUMMARY STEPS 1. enable 2. configure terminal 3. app-hosting appid name 4. app-vnic AppGigabitEthernet trunk 5. vlan vlan-ID guest-interface guest-interface-number 6. guest-ipaddress ip-address netmask netmask 7. multicast 8. exit 9. exit 10. app-default-gateway ip-address guest-interface network-interface 11. end DETAILED STEPS Procedure Application Hosting Enabling Multicast Routing on the AppGigabitEthernet Interface Command or Action Purpose Note You can use either a Layer 2 or a Layer 3 port. Step 11 (Optional) no switchport mode Example:
Device(config-if)# no switchport mode Changes the port from a Layer 2 interface to a Layer 3 interface. Step 12 (Optional) ip address ip-address mask Example: Device(config-if)# 10.1.1.2 255.255.255.0 Configures an IP address for a Layer 3 port. Step 13 (Optional) switchport mode trunk Example: Device(config-if)# switchport mode trunk Sets the interface into permanent trunking mode and negotiates to convert the neighboring link into a trunk link for a Layer 2 port. Step 14 end Example: Device(config-if)# end Exits interface configuration mode and returns to privileged EXEC mode. Command or Action Purpose Step 1 enable Example: Device> enable Enters privileged EXEC mode.
• Enter your password if prompted. Application Hosting 30