Delta Electronics — 6.2.5 AS08TC Control Registers

AS Series Module Manual 6.2.5 AS08TC Control Registers *If you use HWCONFIG to set values in CRs, once the set value is downloaded, the values can be retained in the module; however if you use TO instruction to write data into CRs, the values CANNOT be retained, after power failure or after transition of the CPU from STOP to RUN. 6-10 CR# Name Description Defaults 0 Format Setup 0: integer format 1: floating point format 0 1 Channel 1 mode setup 0: closed 1: -100 mV to +100 mV 2: J-Type 3: K-Type 4: R-Type 5: S-Type 6: T-Type 7: E-Type 8: N-Type 9:

B-Type 1 2 Channel 2 mode setup 3 Channel 3 mode setup 4 Channel 4 mode setup 5 Channel 5 mode setup 6 Channel 6 mode setup 7 Channel 7 mode setup 8 Channel 8 mode setup 9 Channel 1 offset Range: -32768 to +32767 0 10 Channel 2 offset 11 Channel 3 offset 12 Channel 4 offset 13 Channel 5 offset 14 Channel 6 offset 15 Channel 7 offset 16 Channel 8 offset 17 Channel 1 gain Range: -32768 to +32767 1000 18 Channel 2 gain 19 Channel 3 gain 20 Channel 4 gain 21 Channel 5 gain 22 Channel 6 gain 23 Channel 7 gain 24 Channel 8 gain 6