Delta Electronics — 8.2.3.1 AS00SCM-A Power Wiring

Chapter 8 Serial Communication Module AS00SCM 2. CANopen (AS-FCOPM): can only be installed in Card 2; the communication mode can be set to COM/RTU mode. Refer to the following table and use switch to set up. You cannot use ISPSoft (HWCONFIG) to set up the communication mode in this format.  Switch for IP address (AS-FEN02) When using the communication card AS-FEN02, it only supports RTU mode and the IP address can be edited through FORMAT 2. The parameters of AS-FEN02 are stored in AS300 PLC or AS00SCM-A. Thus you need to set up the IP address for AS-FEN02 or use COMMGR to scan and check for the IP address of AS-FEN02. 1.

When both switches ID2 and FORMAT 2 are set to 0, IP address is set through EIP Builder (ISPSoft -> HWCONFIG).  When connected to Delta AS/AH series, you can open HWCONFIG and EIP Builder through ISPSoft. Add AS00SCM (RTU) + AS-FEN02 to your network and click the scanner device from the created network in EIP Builder to open HWCONFIG to set up.  When the scanner is from the third party, you can open EIP Builder directly. Add AS00SCM (RTU) + AS-FEN02 to your network and click the scanner device from the created network in EIP Builder to open HWCONFIG to set up. 2. When either ID2 or FORMAT 2 is NOT 0, IP address is set by switches ID2 and FORMAT 2.

Hexadecimal format is used and ID2 corresponds to x16 1 and FORMAT 2 to x16 0 . The possible IP address is 192.168.1.x, x=1~FE (1~254). 8.2.3 Wiring 8.2.3.1 AS00SCM-A Power Wiring  COM mode: Switch the work mode to COM. Install the module on the right hand side of the AS Series CPU. To avoid problems, do not use an external power supply for this module.  RTU mode: 8_ Switch the work mode to RTU. This module is equipped with an independent DC power connecter. To ensure the serial communication module functions well and reliably, the external wiring must prevent noise. Before you install cables, follow the precautions below.

(1) To prevent a surge and induction, the DC cable and other power cables that are connected to the AS00SCM-A must be separate cables. An independent power supply is recommended for the AS00SCM-A. 8-7 CANopen (AS-FCOPM) Format 2 1 2 3 4 5 6 7 8-F Bit rates (bps) 10K 20K 50K 125K 250K 500K 1000K NA Distance (m) 5000 2500 1000 500 250 100 25 NA