AS Series Module Manual 2. COM and RTU Mode: Refer to the following table and use FORMAT 2 knob to set up the communication. You can NOT use ISPSoft (HWCONFIG) to set up the communication mode in this format. EtherNet/IP (AS-FEN02): can only be installed in Card 2 for RTU mode. When using the communication card AS-FEN02, you need to set ID1 and FORMAT1 to 0. The IP address can be edited through knobs. The parameters of AS-FEN02 are stored in AS300 PLC or AS00SCM-A. Thus you need to use the knobs to set up the IP address for AS-FEN02 or use COMMGR or IP Setup tool to scan and check for the IP address of AS-FEN02. Refer to section 9.4.2 for more information. 1.
When both knobs ID2 and FORMAT 2 are set to 0, IP address is set through EIP Builder (ISPSoft -> HWCONFIG). Open EIP Builder and add AS00SCM (RTU) + AS-FEN02 to your network. Double-click HWCONFIG to set up. Open EIP Builder and select IP Setting Tool from the Tool on the tool bar to scan for the device IP address for setup. 2. When both ID2 and FORMAT 2 are set to F, IP setting mode is in DHCP mode. After setting is complete, you need to turn the power OFF and then ON to make sure the modules are sending DHCP requests. Check the sticker on the AS-FEN02 communication card for the MAC address.
After that open EIP Builder and select IP Manager from the Tool on the tool bar and click Start the Server to set up the correspondences between MAC address and IP address. 3. When either ID2 or FORMAT 2 is NOT 0 or F, IP address is set by knobs ID2 and FORMAT 2. Hexadecimal format is used and ID2 corresponds to x16 1 and FORMAT 2 to x16 0 . The possible IP address is 192.168.1.x, _9 x=1~FE (1~254). PROFINET (AS-FPFN02): You can use the knob to restore back to default settings.
9-6 CANopen (AS-FCOPM) in COM Mode and RTU Mode FORMAT 2 1 2 3 4 5 6 7 8-F Bit rates (bps) 10K 20K 50K 125K 250K 500K 1000K NA Distance (m) 5000 2500 1000 500 250 100 25 NA IP Address Setup (AS-FEN02) in RTU Mode ID1 0 Format 1 0 ID2 0 F Other combination x161 Format 2 0 F x160 IP Address Use ISPSoft (HWCONFIG) DHCP IP Address 192.168.1.x,x=1~FE(1~254) Setup