Delta Electronics — 9.3.2.2 Command

Chapter 9 Serial Communication Module AS00SCM  Length Property : Function: Select Read R ( ) for a variable. And then you can select its corresponding register. The value here is the automatically. The data length can be specified between the packet interval (around 4 character time length). length. Select Constant and then you can define the data length. You can also select to determine the length (*) For a TX packet, you can select the variable and the constant length. For a RX packet, you can select a variable, constant and determine the length (*) automatically.

9.3.2.2 Command After creating several TX and RX packets, create commands to select packets to be sent and packets to be received. Also create a sequence to execute the commands.  Command No. : every command has a number. The Command Number indicates the execution order. You can also use this Command Number to appoint a certain packet for transmission when using Goto function.  Command Type : select Send , Receive , or Send & Receive for the Command Type . Once the type Send is selected, when the packet is sent, the transmission is considered successful. Once the type Send & Receive is selected, AS00SCM-A checks if the received data met the definition of RX packet.

When they are matched, the transmission is considered successful.  Send Packet : select a packet to send.  Receive Packet : select a packet to receive.  Success : specify the action to follow the successful execution of the command: Next , Goto , or End .  Next : the next command is executed based on Command Number. If the command that is being executed is command 1, the next command that will be executed is command 2.  Goto : specify a later command to be executed based on its Command Number. 9_  End : end the sequence of commands.  Fail : specify the action to follow the failure of the command: Next , Goto , or Abort .  Next : the next command is executed based on Command Number.

If the command that is being executed is command 1, the next command that will be executed is command 2.  Goto : specify a later command to be executed based on its Command Number. 9-13