AS Series Module Manual 3. Click Change in the section of Module Definition under the General tab to change the data length (see the image above). You can see the default data size as shown below. Here only shows the data exchange area of AS00SCM. You can find more information on the data size of the right-side modules in the following steps. 4. Digital modules: the data size of every digital modules is incremented in RTU IO Owner . You can refer to the following table for the data size of each module; the unit is INT. When converting INT value to SINT value, the INT value needs to multiply 2 and add the sum to the value to make it a SINT value.
Use AS16AP11P-A as an example, if the INT value is 1 and to convert it to SINT value, the INT value 1 multiplies 2 is 2. Add the sum 2 to the value to make it a SINT value. The input data size is 62 (60+ (1*2)), the output data is 42 (40+(1*2)). _9 9-32 Digital I/O Module I/O Data Length (Unit: INT) ASRTU-FEN02 → EtherNet/IP Scanner EtherNet/IP Scanner → ASRTU-FEN02 (Input) (Output) AS08AM10N-A 1 0 AS08AN01T-A 0 1 AS08AN01P-A 0 1 AS08AN01R-A 0 1 AS16AM10N-A 1 0 AS16AP11T-A 1 1 AS16AP11P-A 1 1 AS16AP11R-A 1 1 AS16AN01T-A 0 1 AS16AN01P-A 0 1 AS16AN01R-A 0 1 AS32AM10N-A 2 0 AS32AN02T-A 0 2 AS64AM10N-A 4 0 AS64AN02T-A 0 4