Delta Electronics — 9.5 Normal Exchange Area

AS Series Module Manual 2) RTU Mode: (AS Series PLC acting as a Scanner)  RTU Error Code: refer to Section 9.7 for more information.  I/O Module Error Code: refer to the I/O module manual for more information.  RTU Operation Status: 0 = communication module stop, 1 = communication module run 3) RTU Mode: (AH Series PLC acting as a Scanner) _9  RTU State: 0 = communication module is working fine, 1 = communication module is NOT working fine.  RTU Error Code: refer to Section 9.7 for more information.  Power State: 0 = power error, 1 = power normal  I/O Module State: each I/O module uses 1 bit to show its status (0 = normal , 1 = not running normally)  I/O Module Error Code:

refer to the I/O module manual for more information.  RTU Operation State: 0 = communication module stop, 1 = communication module run 9-38