Delta Electronics — 10.2.3 AS-F485

Chapter 10 Function Cards 10.1 Introduction Function cards are extension cards such as analog input/output (AI/AO) and communication cards for the AS Series PLC. 10.2 Specification and Function 10.2.1 AS-F232 The AS Series PLC is built with COM1 (RS-485) and COM2 (RS-485) ports. You can use the AS-F232 extension card for communication other interfaces such as RS-232, PC, and so on. Except for the communication interface, however, the master node. After installing the extension card, use HWCONFIG in ISPSoft to configure the communication. communication functions are the same as the built-in ones.

You can set up the communication port as either a slave or a  Wiring example AS-F232 (DB9 female) + + Superior machine 10.2.2 AS-F422 DB9 male to DB9 female (standard cable) communication port. Other than the different communication interface, the communication functions remain the same as Use the AS-F422 extension card to communicate with Delta HMI devices or other devices that use an RS-422 the built-in ones. You can set the communication port as either a slave or a master node. After installing the extension card, use HWCONFIG in ISPSoft to configure the communication.

 Wiring example for communication with Delta HMI DOPA series via COM2 AS-F422 De lta HMI s e rie s DOPA 1 2 6 7 8 9 R+ R- Rx+ Rx- 3 4 T+ T- Tx+ Tx- RTS- RTS+ 3 4 2 1 CTS+ CTS- COM2/DB-9 10.2.3 AS-F485 With its own standalone communication port, the AS-F485 card can work independently and can be either a slave or a master node. After installing the extension card, use HWCONFIG in ISPSoft to configure the communication.  Wiring example Master node Slave node Slave node Terminal resistor (120 ohm) Terminal resistor (120 ohm) 10 10-3 D+ D- SG D+ D- SG SG D+ D- Shielded cable