Chapter 11 DeviceNet Master Scanner Module AS01DNET-A Insert the peeled communication cables into the holes in the connector in correct order. 11 Tighten the screws on the connector by a slotted screwdriver and fix the communication cables in the holes in the connector. 11.5.4 Configuring AS01DNET (in RTU mode) connected to AS01DNET. As DeviceNet slave, AS01DNET (RTU) mainly achieves the data exchange between the master and AS-series I/O modules Transmits output data of DeviceNet master to I/O modules. Transmits input data from I/O modules to DeviceNet master. 11.5.4.1. Terms 11-55 No.
Name Unit Description 1 Control word WORD The first WORD for output data that the master assigns to AS01DNET is the control word of AS01DNET for setting the work mode of AS01DNET. When the content in the control word is set to 2, AS01DNET is in STOP mode. When the content in the control word is set to 1, AS01DNET is in RUN mode. 2 Status word WORD The first WORD for input data that the master assigns to AS01DNET is the status word of AS01DNET for displaying the operation state of AS01DNET. Refer to section 11.5.4.3.4 for more about status word. 5 Range of input data in modules WORD Determined by start input address and input mapping parameter length of each module.
6 Range of output data WORD Determined by start output address and output mapping parameter in modules length of each module. 7 Input data size WORD The sum of the size of status word of AS01DNET and the size of input data of the modules connected to it. The status word occupies one word. Digital input module takes 16 bits as one word. The input data length of analog I/O modules and temperature modules are determined by the default mapping parameter length and user-added parameter length, no more than 20 words. 8 Output data size WORD The sum of the size of control word of AS01DNET and the size of output data of the modules connected to it. The control word occupies one word.
Digital output module takes 16 bits as one word. The output data length