AS Series Module Manual 11.5.4.3. DeviceNet Mapping Data The model of the entire mapping data exchange is displayed below and eventually data will map to the registers in the 11 PLC of the master. PLC DeviceNET IO modules AS01DNET AS01DNET (RTU) Note : All mapping addresses mentioned below means the D registers in the PLC. The start input address and start output address of AS01DNET (RTU) are assigned automatically by the master when AS01DNET (RTU) is added to the master. The input mapping address length and output mapping address length of AS01DNET (RTU) are determined by the configuration of modules connected to AS01DNET (RTU).
mapping address length and output mapping address length are determined by the configuration of the module. The range The start input and output mapping addresses of one I/O module are assigned automatically by the software. Its input of input / output mapping address is limited by the input / output mapping address range of AS01DNET (RTU). 11.5.4.3.1. The Rule for Assignment of Mapping Addresses by AS01DNET Master 11-74