Delta Electronics — 11.5.4.3.2. The Rule for Assignment of Mapping Addresses for AS01DNET (RTU)

Chapter 11 DeviceNet Master Scanner Module AS01DNET-A Data mapping areas are assigned according to the following table. 11 11.5.4.3.2. The Rule for Assignment of Mapping Addresses for AS01DNET (RTU) AS01DNET (RTU) is added to the master. The master assigns mapping addresses of AS01DNET (RTU) according to input The start input and start output mapping addresses of AS01DNET (RTU) are assigned automatically by the master when mapping address length and output mapping address length. Input mapping address length and output mapping address length are determined by the configuration parameters of all modules connected to AS01DNET (RTU).

The start addresses of AS01DNET (RTU) will not be assigned until AS01DNET (RTU) is added to the master and they are related to the order of adding slaves to the master. When there are two slaves of AH10DNET and AS01DNET (RTU), the input size and output size of AH10DNET are both 4 bytes and the input size and output size of AS01DNET (RTU) are both 4 bytes. If AS01DNET (RTU) is added to the master (RTU) are respectively D26005~D26006 and D26105~D26106 as below. D26005 and D26105 are respectively the start before AH10DNET is added to the master, then the input mapping addresses and output mapping addresses of AS01DNET input mapping address and start output mapping address, i.e.

status word and control word of AS01DNET (RTU). The registers after start input mapping address and start output mapping address are for mapping the configuration parameters of I/O modules. 11-75 Input area: Slave  Master Output area: Master  Slave Register in AS PLC Purpose Data size Register in AS PLC Purpose Data size D26000~D26003 Scan-list node state indication area 4 words D26100~D26103 Bit-strobe command area 4 words D26004 Scanner module state indication area 1 word D26104 Reserved 1 word D26005~D26099 DeviceNet input data area; for receiving state data back from slaves 95words D26105~D26199 DeviceNet output area; the data in the registers will be sent to slaves as control data.

95 words