Chapter 13 IO-Link Communication Module AS04SIL 13.4 Application Examples 13.4.1 Using AS Series CPU as Upper Device is placed on the right of AS00SCM-A (RTU mode), the AS-FCOPM communication card need be added to AS00SCM-A. The AS04SIL-A module can be connected on the right side of AS series CPU or AS00SCM-A (RTU mode). If AS04SIL-A AS04SIL-A supports three remote communication modes and communicates with the upper device via CAN port. When the upper device is an AS series CPU, the application situation is as illustrated in the following figure. IO - Link Sensor / Actuator Hub 13 Input IODD file Connect to USB port or Ethernet port of AS series CPU ….. ….. 16x DI DO / Software:
HWCONFIG4 0 . CANopen Builder Sensor / Hub IO - Link CAN IO-Link Binary Ethernet / USB An AS04SIL-A module can connect with 4 IO-Link devices at most. If the hybrid use of the IO-Link devices and multiple Pin2 DI function traditional sensors (binary sensors) is needed, there are two connection methods based on the number of traditional sensors on site. 1. If there is only a small number of traditional sensors to be connected, each of AS04SIL-A module’s ports can connect with one traditional sensor by using the DI function of Pin2 for each port. 2. If there are many traditional sensors to be connected, use the IO-Link hub from other brand to extend the connectable digital I/O devices.
13-17 ator