AS Series Module Manual 13.4.4 Application of Delta Special Driver & AS Remote Mode The device list in the following example is the same as that in section12.4.3. Complete the following setups before the AS00SCM-A module is powered on. 1. The AS-FCOPM card is inserted to AS00SCM-A via Card 2. (The 120Ω terminal resistor is enabled.) _13 2. Use Delta standard cable to connect to AS CPU and the mode switch is turned to RTU mode. 3. Four switches are set to ID1: 0 / FORMAT1: 8 / ID2: 9 / FORMAT2: 7 and the status is set to Delta Special Driver & AS Remote Communication , node ID 9 and baud rate 1Mbps. 4. AS04SIL-A is connected on the right side of AS00SCM (RTU).
Ensure that IO-Link devices are connected to the four ports according to the wiring in section 13.2.3. Switch the power on after the AS-FCOPM card is inserted to AS332T-A via Card 2. (The 120 Ω terminal resistor is enabled.) Open the HWCONFIG 4.0 software, set up function card 2 for AS CPU and then download the settings as follows. The following steps are the same as the operation in section 13.4.3. 13-32 Model name Device type AS332T-A PLC AS00SCM-A RTU AS04SIL-A IO-Link Master AI-B100 3rd IO-Link Device E3S-DCP21-IL3 3rd IO-Link Device MAXREFDES27# 3rd IO-Link Device MAXREFDES36# 3rd IO-Link Device