AS Series Module Manual Troubleshooting Error Codes 14 14-32 Error Description ERR Counter action Remark code LED 16#1605 Counted result in the latched area is not retainable (major error) ON The counter module stops operating and counting The error alarm makes the CPU stop the system. (The module need be set to keep counting or stop for when an error occurs in the module:) 16#1606 Module settings in the latched area is not retainable. (major error) 16#1607 Module setting error (major error) 16#1800 Counter overflow / underflow on CH1 Blinking Linear counter: Counting stops. Ring counter: Counting continues. Linear counter: Counter value overflow inside the hardware Ring counter:
After the Ring Counter Overflow/Underflow Detect function is enabled in the Alarm Setting of HWCONFIG, the alarm will appear when the overflow or underflow occurs. 16#1801 Counter overflow / underflow on CH2 16#1802 Linear count exceeding the set upper/lower limit on CH1 Blinking The counting value is fixed at the set max. counter value or the set min. counter value. The counting inside the hardware persists. When the internal counter value is back within the valid range, the counter returns to normal and the counting value is refreshed.
16#1803 Linear count exceeding the set upper/lower limit on CH2 16#1804 The variation in relation to an SSI encoder position exceeding the limit on CH1 Blinking The counting value is fixed at the most recent correct count value. The variation between two consecutive SSI positions exceeds the setting value. 16#1805 The variation in relation to an SSI encoder position exceeding the limit on CH2 16#1806 Abnormal SSI communication on CH1 Blinking The counting value is fixed at the most recent correct count value.
Encoder disconnection/ wiring error/no power supply to the encoder/ data format error/parity check setting error (Error log will not appear unless five consecutive abnormal situations occur.) 16#1807 Abnormal SSI communication on CH2 16#1808 SSI absolute position cross zero point on CH1 Blinking Counting continues. After the SSI Zero Crossing Detect function is enabled on the Alarm Setting tab page of the HWCONFIG software, the alarm will appear as the absolute position of the SSI encoder crosses the zero position. 16#1809 SSI absolute position cross zero point on CH2