Delta Electronics — 6.26.2 Explanation of High-speed Output Instructions

Chapter 6 Applied Instructions 6_ The following table applies when D 1 selects the odd output points as the output devices.

6-811 Executing an interrupt SM471 SM491 SM511 SM531 SM551 SM571 program when pulse output ends Corresponding I500 I501 I502 I503 I504 I505 interrupt I number The output SM476 SM496 SM516 SM536 SM556 SM576 immediately stops when the instruction is disabled or stops Present output SR460 SR461 SR480 SR481 SR500 SR501 SR520 SR521 SR540 SR541 SR560 SR561 position Start/end frequency SR463 SR483 SR503 SR523 SR543 SR563 (Hz) Ramp-up time (ms) SR464 SR484 SR504 SR524 SR544 SR564 Ramp-down time (ms) SR465 SR485 SR505 SR525 SR545 SR565 Target frequency of SR472 SR473 SR492 SR493 SR512 SR513 SR532 SR533 SR552 SR553 SR572 SR573 the fixed slope S curve mode SR604 SR605 SR606 SR607 SR608 SR609 Present output SR610 SR611 SR612 SR613 SR614 SR615 SR616 SR617 SR618 SR619 SR620 SR621 frequency Output point for D1 Y0.1 Y0.3 Y0.5 Y0.7 Y0.9 Y0.11 Busy flag SM472 SM492 SM512 SM532 SM552 SM572 Completion flag SM473 SM493 SM513 SM533 SM553 SM573 Output stop flag SM474 SM494 SM514 SM534 SM554 SM574 Output completion SM475 SM495 SM515 SM535 SM555 SM575 auto-reset The output SM477 SM497 SM517 SM537 SM557 SM577 immediately stops when the instruction is disabled or stops Present output SR474 SR475 SR494 SR495 SR514 SR515 SR534 SR535 SR554 SR555 SR574 SR575 position