Chapter 5: Advanced Serverboard Setup Reset Button The Reset Button connection is lo- cated on pins 3 and 4 of JF1. Attach it to the hardware reset switch on the computer case. Refer to the table on the right for pin defi nitions. Power Button The Power Button connection is located on pins 1 and 2 of JF1. Mo- mentarily contacting both pins will power on/off the system. This button as a suspend button (see the Power can also be confi gured to function Button Mode setting in BIOS). To turn off the power when set to suspend mode, depress the button for at least 4 seconds. Refer to the table on the right for pin defi nitions.
USB Ports Two Universal Serial Bus ports (USB2.0) are located beside the key- board/mouse ports. See the table on the right for pin defi nitions. USB Headers Two additional USB2.0 head- ers (USB2/3) are included on the serverboard. These may be con- nected to provide front side access. A USB cable (not included) is needed for the connection. See the table on the right for pin defi nitions.
5-13 Reset Button Pin Defi nitions (JF1) Pin# Defi nition 3 Reset 4 Ground Power Button Pin Defi nitions (JF1) Pin# Defi nition 1 PW ON _ 2 Ground Universal Serial Bus Ports Pin Defi nitions (USB0/1) USB0 USB1 Pin # Defi nition Pin # Defi nition 1 +5V 1 +5V 2 PO- 2 PO- 3 PO+ 3 PO+ 4 Ground 4 Ground Universal Serial Bus Headers Pin Defi nitions (USB2/3) USB2 USB3 Pin # Defi nition Pin # Defi nition 1 +5V 1 +5V 2 PO- 2 PO- 3 PO+ 3 PO+ 4 Ground 4 Ground 5 Key 5 No connection