Super Micro Computer, Inc. 1041M-T2+ — Super Micro 1041M-T2+ User Manual: Comprehensive Guide for System Integrators

AS1041M-T2+ User's Manual Serial Ports The COM1 serial port is located be- side the USB ports on the I/O back- plane. COM2 is a header located near the SIMLC slot. Refer to the table on the right for pin defi nitions. Note: NC indicates no connection. Fan Headers The serverboard has nine fan head- ers, which are designated FAN1 through FAN9. Fans speed may be set to full or variable speed with a BIOS setting. See the table on the right for pin defi nitions. FAN4 is for CPU1, FAN3 is for CPU2, Note: when using active heatsinks, Note: Fan speed may controlled by a BIOS setting to change with system temperature. As a result, pin 2 may be either 12V or 9V. See Chapter 4 for BIOS settings.

FAN8 is for CPU3 and FAN7 is for CPU4. Overheat LED Connect an LED to the JOH1 header to provide warning of chassis over- heating. See the table on the right for pin defi nitions. Power LED/Speaker On the JD1 header, pins 1-3 are for a power LED, pins 4-7 are for the speaker. See the table on the right for speaker pin definitions. Note : The speaker connector pins are for use with an external speaker. If you wish to use the onboard speaker, you should close pins 6-7 with a jumper.

5-14 Serial Port Pin Defi nitions (COM1, COM2) Pin # Defi nition Pin # Defi nition 1 DCD 6 DSR 2 RXD 7 RTS 3 TXD 8 CTS 4 DTR 9 RI 5 Ground 10 NC Fan Header Pin Defi nitions (FAN1-9) Pin# Defi nition 1 Ground (Black) 2 +12V/9V (Red) 3 Tachometer Overheat LED Pin Defi nitions (JOH1) Pin# Defi nition 1 +3.3V 2 OH Active Speaker Connector Pin Defi nitions (JD1) Pin # Function Defi nition 4 + Speaker data (red wire) 5 Key No connection 6 Key 7 Speaker data