Wiring ASDA-B3 Connecting multiple servo drives: 3 Controller (1) 1 2 3 4 5 6 7 8 120 Ω (3) (2) (1) Connect to the controller / PLC; (2) Modbus connector; (3) Wiring for RS-485 terminal resistor Note: 1. This supports up to 32 axes via RS-485. The communication quality and the number of connectable axes are determined by the controller’s specifications, quality of wires, grounding, interference, and 2. It is suggested to use a terminal resistor of 120 Ω (Ohm) and 0.5 W (or above). whether a shielded twisted-pair cable is used. 3. To connect multiple servo drives in parallel, use a Modbus connector as shown above, and put the terminal resistor in the last servo drive. 3-60