Wiring ASDA-B3 3.7 Wiring for the CN6 communication connector 3.7.1 Wiring for the DMCNET communication connector 3 The servo drive uses a standard RJ45 connector with a shielded cable to connect to the controller or motion control card for controlling position, torque, and speed, as well as accessing or monitoring the servo status with Delta’s DMCNET system. You can set the station number of DMCNET with P3.000. Its maximum transmission rate is 20 Mbps. Two ports are provided for connecting multiple servo drives, with one way in and the other way out. Remember to put the terminal resistor (120 Ω) in the last servo drive.
1 8 9 16 (1) (2) (1) CN6 connector (female); (2) CN6 connector (male) Pin assignment (same for both connectors): 3-64 Pin No. Signal Description 1, 9 DMCNET 1A _ DMCNET Channel 1 bus line (+) 2, 10 DMCNET 1B _ DMCNET Channel 1 bus line (-) 3, 11 DMCNET 2A _ DMCNET Channel 2 bus line (+) 4, 12, 5, 13 - - 6, 14 DMCNET 2B _ DMCNET Channel 2 bus line (-) 7, 15, 8, 16 - -