ASDA-B3 Wiring Connecting multiple servo drives: 3 Controller (1) 1 2 3 4 5 6 7 8 120 Ω 120 Ω (2) (1) Connection to the controller / motion control card (2) DMCNET terminal resistor (Delta part number: ASD-TR-DM0008) Note: 1. This supports up to 12 axes with the cable length up to 30 m (98.43 ft). 2. It is suggested to use a terminal resistor of 120 Ω (Ohm) and 0.5 W (or above). 3. To connect multiple servo drives in serial, use two sets of DMCNET ports as shown above, and put the terminal resistor in the last servo drive. 3-65