Delta Electronics — 5.2.2 Auto tuning with the drive panel

Tuning ASDA-B3 5.2.2 Auto tuning with the drive panel With the following tuning procedure, use the drive panel to complete auto tuning. Make sure the 5 emergency stop, positive and negative limit switches work properly before you start to tune the system. Flowchart of auto tuning M Press and hold the M key (Mode) and S key (Shift) for four seconds to enter the Auto Tuning mode. S "S-Cmd" on the drive panel is blinking. You can select the internal or external command with the Up or Down key. M S M M Press the S key to set the external command. S S Press the S key to set the internal command. Check the servo status. No No It reminds you to change the status to Servo On.

"Servo Off" is blinking to remind you that the controller has not issued the Servo On command to the drive. Then, it returns to the Auto Tuning mode. Servo On? Servo On? Yes Yes M S Press the S key to set the drive to Servo On. "JOG-S" is blinking to remind you to set the JOG speed. Then, you can set the JOG speed with the Up, Down, and Shift keys. Press the S key to complete the setting of JOG speed. M M S S M S Press the Up and Down keys to set Position 1. M S Press the S key to complete the setting of Position 1. M Press the Up and Down keys to set Position 2. M Press the S key to complete the setting of Position 2.

Then, the system starts to do positioning between the two points that you just set. S S "SPEED" is blinking to remind you to adjust the positioning speed. M S Then, you can set the positioning speed with the Up, Down, and Shift keys. M S M S Press the S key to complete the speed setting. Press the Up and Down keys to select YES or NO. "YES" means the setting is complete. "NO" means you need to keep adjusting the speed. M S Press the S key to start Auto Tuning. The panel shows the percent complete. When you see "Set" displayed on the panel, you can press the S key to complete the setting or press the M key to exit the Auto Tuning mode. Press the M key to exit the Auto Tuning mode.

M S M S Press the S key to complete the setting. Complete 5-6 M S