ASDA-B3 Tuning 5.2.1 Flowchart of auto tuning You can use the drive panel or ASDA-Soft to complete auto tuning. The auto tuning function in the B3 servo drive helps you to find the most suitable parameters for your system according to 5 the machine characteristics. Auto Tuning With the controller: the path is configured by the Without the controller: the back and forth path is set by controller. the servo drive. The drive automatically estimates the inertia and starts to tune the system. Complete Note: when the path is configured by the controller, make sure the dwell time is added to the operation cycle. Otherwise, AL08B occurs and the servo drive cannot complete auto tuning.
You can use P2.105 and P2.106 to adjust the response and stiffness in Auto Tuning mode. See the following flowchart. Start Use the drive panel or ASDA-Soft to enter Auto Tuning mode Satisfied with the stiffness? of P2.105 No Change the setting Yes Satisfied with the response? No Change the setting of P2.106 Yes Complete 5-5