Delta Electronics — 5.2 Auto tuning

Tuning ASDA-B3 5.2 Auto tuning The auto tuning function provided by the ASDA-B3 enables the system to perform real-time 5 machine inertia estimation and upload the tuned parameters to the servo drive. You can use the ASDA-Soft software or the drive panel to start auto tuning. The following table lists the parameters that change with the results of auto tuning.

P1.037 Load inertia ratio P2.000 Position control gain P2.004 Speed control gain P2.006 Speed integral compensation P2.031 Bandwidth response level P2.032 Gain adjustment mode Command response gain (enabling the two-degrees-of- freedom control function (set P2.094 [Bit12] to 1) is required) P2.089 5-4 Gain parameters Parameter Function No. Filter and resonance suppression parameters Parameter Function No.

P1.025 Low-frequency vibration suppression frequency (1) P1.026 Low-frequency vibration suppression gain (1) P1.027 Low-frequency vibration suppression frequency (2) P1.028 Low-frequency vibration suppression gain (2) P2.023 Notch filter frequency (1) P2.024 Notch filter attenuation level (1) P2.025 Resonance suppression low-pass filter P2.043 Notch filter frequency (2) P2.044 Notch filter attenuation level (2) P2.045 Notch filter frequency (3) P2.046 Notch filter attenuation level (3) P2.049 Speed detection filter and jitter suppression P2.098 Notch filter frequency (4) P2.099 Notch filter attenuation level (4) P2.101 Notch filter frequency (5) P2.102 Notch filter attenuation level (5)