Tuning ASDA-B3 5.3.2 Gain adjustment mode 1 In this mode, the servo drive continues to estimate the machine inertia and updates the value of 5 P1.037. Requirements for inertia estimation: 1. The motor accelerates from 0 rpm to 3,000 rpm within 1.5 seconds. 2. It is suggested to set the motor speed to 500 rpm or higher. The lowest speed should be no less than 200 rpm. 3. The load inertia must be no more than 50 times the motor inertia. 4. The change in the inertia ratio cannot be too great. 5.3.3 Gain adjustment mode 2 When Gain adjustment mode 1 cannot meet your need, try Gain adjustment mode 2 to tune the servo system.
In Gain adjustment mode 2, the system does not automatically estimate the inertia. You must set the correct machine inertia in P1.037. Inertia estimation is applicable to most applications. However, when the machine does not comply with the requirements for inertia estimation, you have to set the correct inertia ratio in P1.037.
5-16 P2.032 Adjustment mode Inertia estimation Parameter setting Manual Auto value 1 Gain adjustment mode 1 Real-time estimation P2.031 P1.037, P2.000, P2.004, P2.006, P2.023, P2.024, P2.025, P2.043, P2.044, P2.045, P2.046, P2.049, P2.089, P2.098, P2.099, P2.101, P2.102 P2.032 Adjustment mode Inertia estimation Parameter setting value Manual Auto 2 Gain adjustment mode 2 Fixed set value of P1.037 P1.037, P2.031 P2.000, P2.004, P2.006, P2.023, P2.024, P2.025, P2.043, P2.044, P2.045, P2.046, P2.049, P2.089, P2.098, P2.099, P2.101, P2.102