Tuning ASDA-B3 5.4 Tuning in manual mode The selection of the position or speed response bandwidth should be determined by the 5 machine stiffness and the application. Generally, for applications or machines that require high-speed positioning and high precision, higher response bandwidth is required. However, increasing the response bandwidth might cause mechanical resonance. Thus, machinery with higher stiffness is used to solve this problem. When the response bandwidth is unknown, you can gradually increase the gain parameter values to increase the response bandwidth. Then, decrease the gain parameter values until you hear the sound of the resonance.
The following are the descriptions of the gain adjustment parameters. Position control gain (KPP, P2.000) This parameter determines the response of the position control loop. The bigger the KPP value, the higher the response bandwidth of the position loop. This lowers the following error and position error, and shortens the settling time. However, if you set the value too high, it can cause the machinery to vibrate or cause overshoot when positioning. The calculation of the position loop response bandwidth is as follows: Position loop response bandwidth (Hz) = KPP 2π Speed control gain (KVP, P2.004) This parameter determines the response of the speed control loop.
The bigger the KVP value, the higher the response bandwidth of the speed loop and the lower the following error. However, if you set the value too high, it can cause mechanical resonance. The response bandwidth of the speed loop must be 4 to 6 times higher than that of the position loop. Otherwise, it can cause the machinery to vibrate or cause overshoot when positioning. The calculation of the speed loop response bandwidth is as follows: Speed loop response bandwidth (Hz) = ( KVP (1 + P1.037/10) 2π ) Ч [ (1 + JL/JM) ] JM: motor inertia; JL: load inertia; P1.037:
0.1 (times) When P1.037 (auto estimation or manually set value) is equal to the real load inertia ratio (JL / JM), the real speed loop response bandwidth is: Speed loop response bandwidth (Hz) = ( KVP 2π ) Speed integral compensation (KVI, P2.006) The higher the KVI value, the better the elimination of the deviation. However, if you set the value too high, it can cause the machinery to vibrate. It is suggested that you set the value as follows: KVI ≤1.5 Ч Speed loop response bandwidth (Hz) 5-20