Delta Electronics — 5.4 Tuning in manual mode

ASDA-B3 Tuning  Low-pass filter for resonance suppression (NLP, P2.025) A high load inertia ratio reduces the response bandwidth of the speed loop. Therefore, you must increase the KVP value to maintain the response bandwidth. Increasing the 5 KVP value might cause sound due to mechanical resonance. Use this parameter to eliminate the noise from resonance. The higher the value, the better the capability for reducing high-frequency noise. However, if you set the value too high, it can cause instability in the speed loop and overshoot. It is suggested that you set the value as follows:

NLP ≤ 10000 6 Ч Speed loop response bandwidth (Hz)  Anti-interference gain (DST, P2.026) Use this parameter to increase the ability to resist external force and eliminate overshoot during acceleration / deceleration. The default value is 0. Adjusting this value in Manual mode is not suggested unless it is for fine-tuning. Note: to use this parameter, disable the two-degrees-of-freedom control function (set P2.094 [Bit 12] to 0).  Position feed forward gain (PFG, P2.002) This parameter can reduce the position error and shorten the settling time. However, if you set the value too high, it might cause overshoot when positioning.

If the setting of the E-Gear ratio is larger than 10, it might cause noise as well. Note: to use this parameter, disable the two-degrees-of-freedom control function (set P2.094 [Bit 12] to 0). 5-21