Delta Electronics — 6.2.2 Position command in PR mode

ASDA-B3 Operation Mode 6.2 Position mode Two input modes for position control are available on the ASDA-B3: external pulse (PT mode) and internal register (PR mode). In PT mode, the ASDA-B3 servo drive receives the pulse 6 command for direction (motor runs forward or reverse). You can control the rotation angle of the motor with the input pulse. The ASDA-B3 can receive pulse commands of up to 4 Mpps. You can also accomplish position control using the internal register (PR mode) without the external pulse command. The ASDA-B3 provides 100 command registers with two input modes.

You can set the 100 registers first before switching the drive to Servo On status and then set DI.POS0 - DI.POS6 of CN1 for the switch. Or, directly set the register values through communication. 6.2.1 Position command in PT mode The PT Position command is the pulse input from the terminal block. There are three pulse types and each type has positive and negative logic that you can set in P1.000. Refer to Chapter 8 for more details. 6.2.2 Position command in PR mode The PR command source is the 100 built-in command registers, (P6.000, P6.001) - (P7.098, P7.099).

Use DI (0x11) - (0x1E) (POS0 - POS6 of CN1) to select one of the 100 sets as the Position command and trigger the command with DI.CTRG (0x08). See the following table for more details. Status of POS0 - POS6: 0 means that DI is off (the circuit is open); 1 means that DI is on (the circuit is closed). CTRG : this indicates the moment that DI is switched from off to on. 6-5 Parameter Function P1.000 External pulse input type Position Corresponding POS6 POS5 POS4 POS3 POS2 POS1 POS0 CTRG command parameter Homing 0 0 0 0 0 0 0 ↑ P6.000 P6.001 PR#1 0 0 0 0 0 0 1 ↑ P6.002 P6.003 … … PR#50 0 1 1 0 0 1 0 ↑ P6.098 P6.099 PR#51 0 1 1 0 0 1 1 ↑ P7.000 P7.001 … … PR#99 1 1 0 0 0 1 1 ↑ P7.098 P7.099