ASDA-B3 Motion Control 7.1.3 Motion Control commands The ASDA-B3 provides 100 path setting sets, which include the homing method, Speed command, Position command, Jump command, Write command, and Index Position command. The following sections detail each command type. 7 7.1.3.1 Homing methods The ASDA-B3 provides 11 homing methods in the PR mode, including home sensor, limit, and hard stop as the reference origin. They come with sub-selections such as whether to refer to the Z pulse and the limit signal as the trigger, with more than 30 combinations available. The homing method is specified by P5.004 and the homing definition is determined by P6.000.
The following lists the function of each bit. Settings: Limit setting Y Z U X Reserved Definition of each setting value: 7-9 Address: 0508H P5.004 Homing methods 0509H Default: 0x0000 Control mode: PR Unit: - Setting range: 0x0000 - 0x012A Format: HEX Data size: 16-bit X Homing method Z Y Z pulse setting U U Z Y X Reserved Limit setting Z pulse setting Homing method - 0 - 1 - When reaching the limit: Z = 0: show error Z = 1: reverse direction 0 - 2 0 - 8 Y = 0: return to Z pulse Y = 1: go forward to Z pulse Y = 2: do not look for Z pulse X = 0: homing in forward direction and define the positive limit as the homing origin X = 1:
homing in reverse direction and define the negative limit as the homing origin X = 2: homing in forward direction, ORG: OFFON as the homing origin X = 3: homing in reverse direction, ORG: OFFON as the homing origin - X = 4: look for Z pulse in forward direction and define it as the homing origin X = 5: look for Z pulse in reverse direction and define it as the homing origin Y = 0: return to Z pulse Y = 1: go forward to Z pulse Y = 2: do not look for Z pulse X = 6: homing in forward direction, ORG: ONOFF as the homing origin X = 7: homing in reverse direction, ORG: ONOFF as the homing origin