ASDA-B3 Motion Control Motor’s current position Target position Absolute command (Fb_PUU) (ABS) 60000 PUU position (Fb_PUU) Relative command 0 10000 20000 30000 40000 50000 60000 70000 80000 90000 100000 7 Motor’s current Target position (REL) 60000 PUU 60000 90000 100000 Incremental command (INC) 60000 PUU High-speed position capturing (CAP) 60000 PUU Figure 7.1.3.3.3 Four types of Position command Table 7.1.3.3.1 Bit functions of PR position control Note: 1. Y: OPT: option INS: Interrupt command that interrupts the previous motion command. OVLP: allow overlapping of the next command. CMD: Position command selection. 2. Z, U: ACC / DEC:
acceleration / deceleration time, set by P5.020 - P5.035. 3. A: SPD: target speed, set by P5.060 - P5.075. 4. B: DLY: delay time, set by P5.040 - P5.055.
7-27 0 10000 20000 3 0000 40000 50000 60000 70000 80000 otor’s current Endpoint of Target position previous command 60000 position (Fb _PUU) (Cmd _E) 0 10000 20000 30000 40000 50000 60000 70000 80000 90000 100000 0 10000 20000 3 0000 40000 50000 60000 70000 80000 90000 Capturing 60000 position Target position (Fb PUU) position _ 0 10000 20000 30000 40000 50000 60000 70000 80000 90000 100000 0 10000 20000 30000 40000 50000 60000 70000 D C B A U Z Y X PR parameters Command type - - DLY SPD DEC ACC OPT 2 or 3 Data content Target position [PUU] BIT 3 2 1 0 Description Command type CMD OVLP INS - 0 0 - - ABS (absolute positioning) 0 1 REL (relative positioning) Data content 1 0 INC (incremental positioning) 1 1 CAP (high-speed position capturing)