Delta Electronics — 7.1.4 Overview of the PR procedure

ASDA-B3 Motion Control Index Position command You can use the Index Position command in any PR paths (PR#1 - PR#99). The number of PR paths is determined by the index number. It is marked as “Index Position”. See Figure 7.1.4.7. (1) 7 (2) (3) (4) (5) (6) (7) (8) Figure 7.1.4.7 Index Position command display (1) Index Position command section: the number of the index position. It shows the total moving distance at the top using double arrows to show that the motor can run reciprocally between each target position in each PR path. (2) Command execution type (property): a Position command can interrupt (INS) the previous PR path.

If the Interrupt function is enabled, it displays (I); if not, no information is displayed. The Index Position command can overlap (OVLP) the next PR path. Before using the Overlap function, set the delay time to 0. If the Overlap function is enabled, it displays (O); if not, no information is displayed. (3) Delay time (DLY): determined by the shared PR parameters. It is defined by a command from the controller. The servo starts counting the delay time once reaching the target position. (4) Position command: the numerator is the position of this PR path; the denominator is the total moving distance of this Index Position command, which is set by P2.052. (5) Rotation direction (Dir):

available options are “Rotation forward (Forward)”, “Rotation in reverse (Reverse)”, and “Rotation with the shortest distance (Shortest)”. (6) Target speed: determined by the shared PR parameters. (7) Acceleration time (ACC): determined by the shared PR parameters; length of time to reach the target speed from stopped. (8) Deceleration time (DEC): determined by the shared PR parameters; length of time to decelerate from target speed to stopped.

7-41 Index Position List [100000] PR#1 (I)(O) PR#2 (I)(O) PR#3 (I)(O) Index Position Index Position Index Position DLY = [0] 0 ms DLY = [0] 0 ms DLY = [0] 0 ms 0/100000 PUU 33333/100000 PUU 66667/100000 PUU Dir = [0] Forward Dir = [0] Forward Dir = [0] Forward Speed = 200 rpm Speed = 200 rpm Speed = 200 rpm Acc = [0] 6.67 ms Acc = [0] 6.67 ms Acc = [0] 6.67 ms Dec = [0] 6.67 ms Dec = [0] 6.67 ms Dec = [0] 6.67 ms