Motion Control ASDA-B3 Jump command You can use the Jump command in any PR paths (PR#1 - PR#99). It is marked as “Jump” and followed by an arrow pointing to the next PR path. See Figure 7.1.4.5. 7 (1) (2) (3) Figure 7.1.4.5 Jump command display (1) Command execution type (property): a Jump command can interrupt (INS) the previous PR path. If the Interrupt function is enabled, it displays (I); if not, no information is displayed. (2) Delay time (DLY): determined by the shared PR parameters. (3) Target PR number: the set target PR number. Write command You can use the Write command in any PR paths (PR#1 - PR#99). It is marked as “Write”. See Figure 7.1.4.6.
(1) (2) (3) Figure 7.1.4.6 Write command display (1) Command execution type (property): a Write command can interrupt (INS) the previous PR path. If the Interrupt function is enabled, it displays (I); if not, no information is displayed. You can determine whether to write the data to EEPROM. If writing data to EEPROM is required, it shows (R); if not, no information is displayed. (2) Delay time (DLY): determined by the shared PR parameters. (3) Writing target and data source: the corresponding target and data sources are shown in the following table. Note that constants can be written in DEC or HEX format.
7-40 PR#1 (I) Jump DLY = [0] 0 ms PR#2 PR#1 (I)(R) Write DLY = [0] 0 ms P1.001 = 1 Writing Target Data source Parameter (PX.XXX) Constant Data array (Arr[#]) Parameter (PX.XXX) - Data array (Arr[#]) - Monitoring variable (Mon[#])