Delta Electronics — 8.2 List of parameters

ASDA-B3 Parameters Planning of digital input / output pin and output parameters (continued) 8 ( ★ ) Read-only parameter. Can only read the value of the parameter. For example, P0.000, P0.010, and P4.000. (▲) Parameter cannot be changed when servo is in Servo On status. For example, P1.000 and P1.046. ( ● ) Parameter changes become valid after power cycling. For example, P1.001 and P3.000. ( ■ ) Parameter resets to its default value after power cycling. For example, P3.006. Communication parameters 8-11 Parameter Control mode Function Default value Unit No.

PT PR S T P2.038 DI11 functional planning 0x0100 - O O O O P2.039 DI12 functional planning 0x0100 - O O O O P2.040 DI13 functional planning 0x0100 - O O O O P2.041 DO6 functional planning 0x0100 - O O O O P1.038 Zero speed range 10.0 (panel / software) 1 rpm (panel / software) O O O O 100 (communication) 0.1 rpm (communication) P1.039 Target speed detection level 3000 rpm O O O O P1.042 Enable delay time for magnetic brake 0 ms O O O O P1.043 Disable delay time for magnetic brake 0 ms O O O O P1.047 Speed reached (DO.SP OK) range _ 10 rpm - - O - P1.054 Pulse range for position reached 167772 pulse O O - - P1.056 Motor output overload warning level 120 % O O O O Control mode Parameter Function Default value Unit No.

PT PR S T P3.000● Address 0x007F - O O O O P3.001● Transmission speed 0x0203 0x3203 (B3-F) - O O O O P3.002 Communication protocol 0x0006 - O O O O P3.003 MODBUS communication error handling 0x0000 - O O O O P3.004 Communication timeout 0 sec O O O O P3.006■ Digital input (DI) control switch 0x0000 - O O O O P3.007 MODBUS communication response delay time 0 0.5 ms O O O O