Delta Electronics — 8.2 List of parameters

Parameters ASDA-B3 Diagnosis parameters 8 ( ★ ) Read-only parameter. Can only read the value of the parameter. For example, P0.000, P0.010, and P4.000. (▲) Parameter cannot be changed when servo is in Servo On status. For example, P1.000 and P1.046. ( ● ) Parameter changes become valid after power cycling. For example, P1.001 and P3.000. ( ■ ) Parameter resets to its default value after power cycling. For example, P3.006. 8-12 Control mode Parameter Function Default value Unit No.

PT PR S T P4.000★ Fault record (N) 0x00000000 - O O O O P4.001★ Fault record (N-1) 0x00000000 - O O O O P4.002★ Fault record (N-2) 0x00000000 - O O O O P4.003★ Fault record (N-3) 0x00000000 - O O O O P4.004★ Fault record (N-4) 0x00000000 - O O O O P4.005 Servo motor JOG control 20 rpm O O O O P4.006■ Digital output register (readable and writable) 0x0000 - O O O O P4.007■ Multi-function for digital input 0x0000 - O O O O P4.008★ Input status of servo drive panel (read- only) - - O O O O P4.009★ Digital output status (read-only) - - O O O O P4.010▲■ Adjustment function 0 - O O O O P4.011 Analog speed input (1) offset adjustment Factory setting - O O O O P4.012 Analog speed input (2) offset adjustment Factory setting - O O O O P4.013 Analog torque input (1) offset adjustment Factory setting - O O O O P4.014 Analog torque input (2) offset adjustment Factory setting - O O O O P4.015 Current encoder (V1 phase) offset adjustment Factory setting - O O O O P4.016 Current encoder (V2 phase) offset adjustment Factory setting - O O O O P4.017 Current encoder (W1 phase) offset adjustment Factory setting - O O O O P4.018 Current encoder (W2 phase) offset adjustment Factory setting - O O O O P4.019 IGBT NTC adjustment level (cannot reset) Factory setting - O O O - P4.020 Offset adjustment for analog monitor output (Ch1) 0 mV O O O O P4.021 Offset adjustment for analog monitor output (Ch2) 0 mV O O O O P4.022 Analog speed input offset 0 mV - - O - P4.023 Analog torque input offset 0 mV - - - O