ASDA-B3 Parameters 8 Settings: The fifth to last abnormal status record. Low word (LXXXX): the alarm number. High word (hYYYY): the alarm number. Settings: The control methods are as follows: 1. Operation test: After the JOG speed is set by P4.005, the panel displays “JOG”. Pressing the UP key controls the JOG operation in the positive direction; pressing the DOWN key controls the JOG operation in the negative direction. Stop pressing to stop the JOG operation. If there is any error in this setting, then the motor cannot operate. The maximum JOG speed is the maximum speed of the servo motor. 2. DI control:
If you set the DI to JOGU and JOGD (refer to Table 8.1), then the JOG operation in the positive or negative direction is controlled with this DI. 3. Communication control: Note: when using communication to write values, and the frequency is high, set P2.030 to 5. Settings: 8-101 Address: 0408H P4.004★ Fault record (N-4) 0409H Default: 0x00000000 Control mode: All Unit: - Setting range: - Format: HEX Data size: 32-bit Address: 040AH P4.005 Servo motor JOG control 040BH Default: 20 Control mode: All Unit: rpm Setting range: 0 - 5000 (rotary motor) Format: DEC Data size: 16-bit 1 - 5000: JOG speed 4998: JOG operation in counterclockwise direction 4999: JOG operation in clockwise direction 0:
stop operation Address: 040CH P4.006■ Digital output register (readable and writable) 040DH Default: 0x0000 Control mode: All Unit: - Setting range: 0x0000 - 0xFFFF Format: HEX Data size: 16-bit bit 00: corresponds to DO code = 0x30 bit 08: corresponds to DO code = 0x38 bit 01: corresponds to DO code = 0x31 bit 09: corresponds to DO code = 0x39 bit 02: corresponds to DO code = 0x32 bit 10: corresponds to DO code = 0x3A bit 03: corresponds to DO code = 0x33 bit 11: corresponds to DO code = 0x3B bit 04: corresponds to DO code = 0x34 bit 12: corresponds to DO code = 0x3C bit 05: corresponds to DO code = 0x35 bit 13: corresponds to DO code = 0x3D