Delta Electronics — P4.xxx Diagnosis parameters

ASDA-B3 Parameters 8 Settings: There is no difference whether reading by panel or through communication. Settings: Note: the function must be enabled by setting P2.008. When adjusting, the external analog voltage wiring connected to the torque needs to be removed completely and must be in the Servo Off state. Settings: Manually adjust the offset. The function must be enabled by setting P2.008. Do not change the auxiliary adjustment as this parameter cannot be reset. Settings: Manually adjust the offset. The function must be enabled by setting P2.008. Do not change the auxiliary adjustment as this parameter cannot be reset. 8-103 Address:

0412H P4.009★ Digital output status (read-only) 0413H Default: - Control mode: All Unit: - Setting range: 0x0000 - 0x001F Format: HEX Data size: 16-bit Address: 0414H P4.010▲■ Adjustment function 0415H Default: 0 Control mode: All Unit: - Setting range: 0 - 6 Format: DEC Data size: 16-bit 0: reserved 4: execute current encoder (W phase) offset adjustment 1: execute analog speed input offset adjustment 5: execute 1 - 4 offset adjustment 2: execute analog torque input offset adjustment 6 - 14: reserved 3: execute current encoder (V phase) offset adjustment - Address: 0416H P4.011 Analog speed input (1) offset adjustment 0417H Default: Factory setting Control mode: All Unit: - Setting range:

0 - 32767 Format: DEC Data size: 16-bit Address: 0418H P4.012 Analog speed input (2) offset adjustment 0419H Default: Factory setting Control mode: All Unit: - Setting range: 0 - 32767 Format: DEC Data size: 16-bit