Parameters ASDA-B3 8 Settings: If the position reset function is enabled (P5.039.X [Bit 1] = 1), after the first position data is captured, the servo resets the coordinates of the first point, which is defined by this parameter. Settings: Before executing the macro command, set the relevant parameters in advance. The function of the parameter is determined by the macro command. Not every macro command requires this parameter. Settings: Before executing the macro command, set the relevant parameters in advance. The function of the parameter is determined by the macro command. Not every macro command requires this parameter. Settings:
Before executing the macro command, set the relevant parameters in advance. The function of the parameter is determined by the macro command. Not every macro command requires this parameter. 8-126 Address: 0598H P5.076 Capture - reset position after first data 0599H Default: 0 Control mode: All Unit: Pulse unit of capture source Setting range: -1073741824 to +1073741823 Format: DEC Data size: 32-bit P 5.077 - Reserved P5.092 Address: 05BAH P5.093 Motion control macro command: command parameter #4 05BBH Default: 0 Control mode: All Unit: - Setting range: 0x00000000 - 0xFFFFFFFF Format: HEX Data size: 32-bit Address: 05BCH P5.094 Motion control macro command:
command parameter #3 05BDH Default: 0 Control mode: All Unit: - Setting range: -2147483648 to +2147483647 Format: DEC Data size: 32-bit Address: 05BEH P5.095 Motion control macro command: command parameter #2 05BFH Default: 0 Control mode: All Unit: - Setting range: -2147483648 to +2147483647 Format: DEC Data size: 32-bit