Parameters ASDA-B3 8 Note: the output function is disabled when P2.018 - P2.022 are set to 0. 8-186 Value: 0x3C Triggering Control DO name Description method mode Output bit 12 of P4.006. Level triggered Value: 0x3D Triggering Control DO name Description method mode Output bit 13 of P4.006. Level triggered Value: 0x3E Triggering Control DO name Description method mode SPO E _ Output bit 14 of P4.006. Level triggered All Value: 0x3F Triggering Control DO name Description method mode SPO F _ Output bit 15 of P4.006. Level triggered All Value:
when DI.ABSE is on, DI.ABSR triggered by DO2 will replace the DO2 assigned by P2.019 Triggering Control DO name Description method mode ABSR always output by DO2 When DO.ABSR is off, it indicates servo drive can receive request issued by DI.ABSQ; when DO.ABSR is on, it indicates after receiving the request, the data has been prepared and the ABSD data is valid so that the controller can access the ABSD data. This output is only valid when DI.ABSE is on. Refer to Figure 10.3.5.1.1 for the timing diagram. Level triggered All Value:
when DI.ABSE is on, DI.ABSD triggered by DO3 will replace the DO3 assigned by P2.020 Triggering Control DO name Description method mode ABSD always output by DO3 DO pin of ABS data. The data is valid when DO.ABSR is on. This output is only valid when DI.ABSE is on. Refer to Figure 10.3.5.1.1 for the timing diagram. Level triggered All