Delta Electronics — Table 8.3 Monitoring variables descriptions

ASDA-B3 Parameters Table 8.3 Monitoring variables descriptions Description of monitoring variables: 8 The property code of each monitoring variable is described in the following table: Monitoring variables are described in the following table by the code sequence: 8-187 Item Description Monitoring code Each monitoring variable has a code, and you can use P0.002 to set the code for monitoring the variable. Format Each monitoring variable is stored in the 32-bit format (long integer) of the servo drive. Category Basic variables / expansion variables: 1. Basic variables:

variables (P0.002 = 0 to 26) within the cycle; in monitoring mode, use the UP / DOWN keys on the panel to display the variables. 2. Expansion variables: variables other than basic variables. (P0.002 = 80, -91, -124, and 27 to 127) Monitoring method Panel display / mapping: 1. Panel display: monitor with the panel 2. Mapping: monitor variables or parameters by mapping parameters Panel display 1. Use the MODE key to switch to the monitor mode and press the UP / DOWN keys to select the variable to monitor. 2. Input the variable code to monitor into P0.002 and start monitoring.

Press the SHIFT key on the panel to switch between high and low digit display; Press the SET key on the panel to switch between decimal and hexadecimal display. Mapping 1. Parameters that support monitoring variable mapping: P0.009 - P0.013. Refer to Section 8.3 Parameter descriptions. 2. Read the monitoring variables through communication using mapping parameters. 3. The values of the mapping parameters (P0.009 - P0.013) are the content of the basic variables (17h, 18h, 19h, and 1Ah). To monitor P0.009, set P0.017 to the value to read (refer to P0.002). Read the data specified by P0.017 through communication.

Or, set P0.002 to 23, and the panel displays “VAR-1” and then the content value of P0.009. Property Description B BASE: basic variables. Select the variables with the UP / DOWN keys on the panel. D1 D2 Decimal place displayed on the panel: D1 indicates 1 decimal place; D2 indicates 2 decimal places. Dec Only decimal display is available on the panel, and you cannot switch to hexadecimal display by pressing the SET key. Hex Only hexadecimal display is available on the panel, and you cannot switch to decimal display by pressing the SET key. D1 D2 Code Variable name / property Description 000 (00h) Feedback position (PUU) B Current feedback position of the motor encoder. Unit:

Pulse of User Unit (PUU). 001 (01h) Position command (PUU) B Current coordinate of the Position command. Unit: Pulse of User Unit (PUU). PT mode: number of pulse commands received by the servo drive. PR mode: absolute coordinates of the Position command. 002 (02h) Position deviation (PUU) B Deviation between the Position command and the feedback position. Unit: Pulse of User Unit (PUU). 003 (03h) Feedback position (pulse) B Current feedback position of the motor encoder. Unit: encoder unit (pulse). 004 (04h) Position command (pulse) B Current coordinate of the Position command. Unit: encoder unit (pulse). This is the command after the E-Gear ratio conversion.