Parameters ASDA-B3 8 8-188 Code Variable name / property Description 005 (05h) Position deviation (pulse) B Deviation between the Position command and the feedback position. Unit: encoder unit (pulse). 006 (06h) Pulse command frequency B Frequency of the pulse command received by the drive. Unit: Kpps. Applicable to PT / PR modes. 007 (07h) Speed feedback B D1 Dec Current motor speed. Unit: 0.1 rpm. This is the speed after applying the low-pass filter, which makes it more stable. 008 (08h) Speed command (analog) B D2 Dec Speed command from the analog channel. Unit: 0.01 Volt. 009 (09h) Speed command (integrated) B Integrated Speed command. Unit: 0.1 rpm.
Source includes analog, register, or position loop. 010 (0Ah) Torque command (analog) B D2 Dec Torque command from the analog channel. Unit: 0.01 Volt. 011 (0Bh) Torque command (integrated) B Integrated Torque command. Unit: percentage (%). Source includes analog, register, or position loop. 012 (0Ch) Average load rate B Average load rate (moving average every 20 ms) from the servo drive. Unit: percentage (%). 013 (0Dh) Peak load rate B Maximum load rate from the drive. Unit: percentage (%). 014 (0Eh) DC Bus voltage B Rectified capacitor voltage. Unit: Volt. 015 (0Fh) Load inertia ratio B D1 Dec Ratio of the load inertia to the motor inertia. Unit: 0.1 times.
016 (10h) IGBT temperature B Temperature of IGBT. Unit: °C. 017 (11h) Resonance frequency B Dec Resonance frequency of the system consists of two groups of frequencies: F1 and F2. When monitoring from the panel, press the SHIFT key to switch between F1 and F2: F2 displays zero decimal places; F1 displays 1 decimal place. F2 displays zero decimal places; F1 displays 1 decimal place. When reading by communication (mapping parameter): Low word returns frequency F2. High word returns frequency F1. 018 (12h) Z phase offset B Dec Offset value between motor position and Z phase; range: -4999 to +5000. Where it overlaps with Z phase, the value is 0; the greater the value, the greater the offset.
019 (13h) Mapping parameter content #1 B Returns the value of P0.025 which is mapped by P0.035. 020 (14h) Mapping parameter content #2 B Returns the value of P0.026 which is mapped by P0.036. 021 (15h) Mapping parameter content #3 B Returns the value of P0.027 which is mapped by P0.037. 022 (16h) Mapping parameter content #4 B Returns the value of P0.028 which is mapped by P0.038. 023 (17h) Mapping monitoring variable #1 B Returns the value of P0.009 which is mapped by P0.017. 024 (18h) Mapping monitoring variable #2 B Returns the value of P0.020 which is mapped by P0.018.