ASDA-B3 Parameters 8 8-189 Code Variable name / property Description 025 (19h) Mapping monitoring variable #3 B Returns the value of P0.011 which is mapped by P0.019. 026 (1Ah) Mapping monitoring variable #4 B Returns the value of P0.012 which is mapped by P0.020. 035 (23h) Indexing coordinate command Current command for the indexing coordinates. Unit: Pulse of User Unit (PUU). 038 (26h) Voltage level of the battery Voltage level of the battery in an absolute encoder. To display the voltage level, enable the absolute encoder setting (P2.069). 039 (27h) DI status (integrated) Hex Integrated DI status of the drive. Each bit corresponds to one DI channel.
Source includes hardware channel / P4.007, which is determined by P3.006. 040 (28h) DO status (hardware) Hex Actual status from the DO hardware. Each bit corresponds to one DO channel. 041 (29h) Status of the drive Returns P0.046. Refer to the description of this parameter. 043 (2Bh) CAP data capturing The latest data captured by CAP hardware. Note: CAP can continuously capture multiple points. 049 (31h) Pulse command CNT Pulse counts from the pulse command (CN1). 050 (32h) Speed command (integrated) D1 Dec Integrated Speed command. Unit: 0.1 rpm. Source includes analog, register, or position loop. 051 (33h) Speed feedback (immediate) D1 Dec Current actual motor speed. Unit: 0.1 rpm.
053 (35h) Torque command (integrated) D1 Dec Integrated Torque command. Unit: 0.1%. Source includes analog, register, or position loop. 054 (36h) Torque feedback D1 Dec Current actual motor torque. Unit: 0.1%. 055 (37h) Current feedback D2 Dec Current actual motor current. Unit: 0.01 ampere (Amp). 056 (38h) DC Bus voltage D1 Dec Rectified capacitor voltage. Unit: 0.1 Volt. 064 (40h) Endpoint register of PR command In PR mode, the endpoint of the Position command (Cmd E). _ 065 (41h) Output register of PR command In PR mode, the accumulative output of the Position command. 067 (43h) PR target speed Target speed specified in the PR path. Unit: PPS (pulse per second).
072 (48h) Speed command (analog) B D1 Dec Speed command from the analog channel. Unit: 0.1 rpm. 081 (51h) Capture synchronous axis Incremental pulse input When the synchronous Capture axis is enabled, the actual Mark distance can be measured by the received pulse number between two captures. 084 (54h) Capture synchronous axis Pulse number of synchronous deviation The accumulative deviation between the actual output pulse and the target pulse when the synchronous Capture axis is enabled. This value is close to 0 if synchronization is reached. 091 (5Bh) Indexing coordinate feedback Immediate feedback position of the indexing coordinates. Unit: Pulse of User Unit (PUU).