Delta Electronics — 10.2.2 Installing and replacing a battery

ASDA-B3 Absolute System 10.2.2 Installing and replacing a battery Single battery box 10 Step 1: Release the snap-fit tabs on both sides and remove the battery box cover. Step 2: Position the cable clamp to the encoder connection cable. Note that the cable clamp should be placed close to the heat shrink tube. (A) Cable clamp; (B) Heat shrink tube Step 3: Plug in the lead wire and tighten the cable clamp screw. Step 4: Install a new battery and connect the wire. (C) Replace the battery only when the main power to the servo drive is still on. Do not remove the power cable, or else the system may lose data. Step 5: Place the battery wire into the box and fit the cover. 10-11