ASDA-B3 CANopen Mode 11.3 CANopen operation mode This section describes the servo motion mode (Mode of Operation) specified by CiA402 in CANopen mode. The content includes basic operation settings and related object descriptions. 11 11.3.1 Profile Position Mode After the servo drive receives the position command transmitted by the controller, the servo drive controls the servo motor to reach the target position. In the position control mode, the controller only informs the servo drive of the target position, speed command, and acceleration / deceleration settings at the beginning.
The motion plan from command triggering to the arrival of the target position is performed by the motion command generator in the servo drive. The following figure shows the position control mode architecture of the servo drive:
Servo motor M Position window (6067h) Encoder Position window time (6068h) Statusword (6041h) Bit 10 Target reached Window compara- tor window comparator Position + - E-Gear ratio Position actual value (6064h) 6093h sub2 6093h sub1 Following error actual value (60F4h) Position demand value - + Following error window (6065h) (6062h) 11-17 arget position (607Ah) Position [PUU] Software position limit limit (607Dh) function Profile velocity (6081h) Speed [PUU/s] limit ax profile velocity (607Fh) function Trajectory rofile acceleration (6083h) generator rofile deceleration (6084h) Quick stop deceleration [ms] (6085h) Acceleration limit function Max acceleration (60C5h) Max deceleration (60C6h) Torque actual value (6077h) Velocity actual value (606Ch) Following error comparator