Delta Electronics — 11.2.2.6 NMT services

CANopen Mode ASDA-B3 The servo drive can play two roles simultaneously, the consumer and producer, but you need to set OD 1016h and OD 1017h at the same time. And the controller must also be set as the 11 producer and consumer.  Node / Life Guarding The Node / Life Guarding mechanism is similar to that of Heartbeat. The main difference between the two is that Heartbeat only uses the consumer to judge whether there are packets or not, and the producer does not make this judgment. The mechanism of Node / Life Guarding is mainly based on the master-slave axis and the two-way relationship.

The master axis periodically sends packets to the slave axis, and the slave axis must return the packets to the master axis within the set guard time (OD 100Ch), otherwise an error occurs. You must set the life time for the slave axis and the master slave must send the packets within the life guard time. If the slave axis does not receive the packets, AL180 is triggered. Life time is set by multiplying the guard time by a life time factor (OD 100Dh). The Node / Life Guarding architecture is as follows:

COB-ID = 700h + Node-ID Bit 11-16 COB-ID COB-ID Bit 7 6 - 0 COB-ID COB-ID Bit 7 6 - 0 No signal Master Node uarding time Master Slave Node Life time Slave Life Guarding event Master Node uarding time Node Guarding event Master Bit 7 6 - 0 Bit 7 6 - 0 7 6 5 4 3 2 1 0 Bit Function Description Bit 6 - Bit 0 State of the NMT slave 4 = Stopped 5 = Operational 127 = Pre-operational Bit 7 - -