Delta Electronics — 11.3.1 Profile Position Mode

ASDA-B3 CANopen Mode Command to take immediate effect In the position control mode, set the command to take effect immediately or not with 6040h Bit 5.  When 6040h Bit 5 is set to 0, the command to take immediate effect is disabled. 11 If the command to take immediate effect is not enabled, when the current motion command is in execution (not yet complete), the servo continues to execute the current motion command even if a new command is triggered. The new command is only acknowledged and executed after the current command is complete.

Position Target position (607Ah) 20000 PUU 50000 PUU Time Command 1 triggered (6040h Bit 4) 0 Speed Velocity actual value (606Ch) Execute current position Set-point acknowledge (6041h Bit 12) 1 0 Target reached (6041h Bit 10) 1 0 11-19 60000 PUU/s 30000 PUU/s 20000 PUU 50000 PUU